NORD Drivesystems BU0200 User Manual
Page 237
SK 200E Manual for frequency inverters
236
Subject to technical alterations
BU 0200 GB-4411
Parameter
Setting value / Description / Note
Device
Supervisor
Parameter
set
P748
Status CANopen
(CANopen status (system bus status))
0000 ... FFFF
(hex)
or
0 ... 65535
(dec)
Displays the system bus status.
Bit 0:
Bit 1:
Bit 2:
Bit 3:
Bit 4:
Bit 5:
Bit 6:
Bit 7:
Bit 8:
Bit 9:
Bit 10:
24V Bus supply voltage
CANbus in "Bus Warning" status
CANbus in "Bus Off" status
System bus → Bus module online (field bus module, e.g.: SK xU4-PBR)
System bus → Additional module 1 online (I/O - module, e.g.: SK xU4-IOE)
System bus → Additional module 2 online (I/O - module, e.g.: SK xU4-IOE)
The protocol of the CAN module is 0 = CAN / 1 = CANopen
vacant
"Bootsup Message" sent
CANopen NMT State
CANopen NMT State
CANopen NMT State
Bit 10
Bit 9
Stopped
Pre-Operational
Operational
0
0
1
0
1
0
P749
Status DIP switches
0000 ... 00FF
(hex)
or
0 ... 511
(dec)
Bit 8: from SW1.3
This parameter shows the actual setting of the FI DIP switch "S1" (See Section 5.2.2.2)
Bit 0:
Bit 1:
Bit 2:
Bit 3:
Bit 4:
Bit 5:
Bit 6:
Bit 7:
Bit 8:
DIP switch 1
DIP switch 2
DIP switch 3
DIP switch 4
DIP switch 5
DIP switch 6
DIP switch 7
DIP switch 8
EEPROM (Memory Module)
Bit 8 = 0: plugged in / Bit 8 = 1: not plugged in