IAI America XSEL-KX - Manual (Page 346)

330
A
pp
end
ix
(In the panel window, the three digits after “E” indicate an error number.)
Error No. Error name Description, action, etc.
A05 Motorola S record format error The update program file is invalid. Check the file.
A06 Motorola S checksum error The update program file is invalid. Check the file.
A07 Motorola S load address error The update program file is invalid. Check the file.
A08 Motorola S write address over error The update program file is invalid. Check the file.
A09 Flash-ROM timing limit over error (Write) Error writing the flash ROM
A0A Flash-ROM timing limit over error (Erase) Error erasing the flash ROM
A0B Flash-ROM verify error Error erasing/writing the flash ROM
A0C Flash-ROM ACK timeout Error erasing/writing the flash ROM
A0D Head sector number specification error Error erasing the flash ROM
A0E Sector count specification error Error erasing the flash ROM
A0F Write-destination offset address error (Odd-numbered address) Error writing the flash ROM
A10 Write-source data buffer address error (Odd-numbered address) Error writing the flash ROM
A11 Invalid core-code sector block ID error The core program already written to the flash ROM is invalid.
A12 Core-code sector block ID erase count over The number of times the flash ROM can be erased was exceeded.
A13 Flash-ROM write request error when erase is incomplete When updating, a flash-ROM write command was received before a flash-ROM
erase command. Check the update program file and perform update again.
A14 Busy-status reset timeout error at EEPROM write A busy-status reset timeout occurred after executing EEPROM write.
A15 EEPROM write request error due to no-EEPROM in target An EEPROM write request was received for a driver or other unit with CPU not
equipped with EEPROM.
A16 EEPROM read request error due to no-EEPROM in target An EEPROM read request was received for a driver or other unit with CPU not
equipped with EEPROM.
A17 Message checksum error (IAI protocol reception) The checksum in the received message is invalid.
A18 Message header error (IAI protocol reception) The header in the received message is invalid. Invalid header position (message
is 9 bytes or less) is suspected, among other reasons.
A19 Message station number error (IAI protocol reception) The station number in the received message is invalid.
A1A Message ID error (IAI protocol reception) The ID in the received message is invalid.
A1C Message conversion error The transmitted message does not match the message format or contains
invalid data. Check the transmitted message.
A1D Start mode error A start not permitted in the current mode (MANU/AUTO) was attempted.
A1E Start condition non-satisfaction error Start was attempted when the start condition was not satisfied, such as when an
all-operation-cancellation factor (see the 7-segment display: Drive-source cutoff,
mode switching, error, auto-start switch OFF edge, deadman switch, safety
gate, emergency stop, etc.) was present or the flash ROM was being written.