3Com Wireless LAN WX1200 - Manual (Page 67)

clear port preference 67
Examples — The following command clears the names of ports 1
through 3:
WX4400# clear port 1-3 name
See Also
„
display port status on page 73
„
set port name on page 86
clear port
preference Resets a gigabit Ethernet port on a WX4400 to use the GBIC (fiber)
interface for the active link.
Syntax — clear port preference port-list
„
port-list — List of physical ports. MSS clears the preference on all
the specified ports.
Defaults — When both the copper and fiber interfaces of a gigabit
Ethernet port are connected, the GBIC (fiber) interface is the active link.
The RJ-45 (copper) link is unused.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — This command applies only to the WX4400. This command
does not affect a link that is already active on the port.
Examples — The following command clears the preference set on port 2
on a WX4400 switch:
WX4400# clear port preference 2
See Also
„
display port preference on page 72
„
set port preference on page 88