3Com Wireless LAN WX1200 - Manual (Page 275)

clear network-domain mode 275
clear
network-domain
mode Removes the Network Domain seed or member configuration from the
WX switch.
Syntax — clear network-domain mode {seed | member}
„
seed — Clears the Network Domain seed configuration from the WX
switch.
„
member — Clears the Network Domain member configuration from
the WX switch.
Defaults — None.
Access — Enabled.
History —Introduced in MSS 4.1.
Usage — This command has no effect if the WX switch is not configured
as part of a Network Domain.
Examples — The following command clears the Network Domain
member configuration from the WX switch:
WX1200# clear network-domain mode member
success: change accepted.
The following command clears the Network Domain seed configuration
from the WX switch:
WX1200# clear network-domain mode seed
success: change accepted.
See Also
„
set network-domain mode member seed-ip on page 280
„
set network-domain mode seed domain-name on page 282