3Com Wireless LAN WX1200 - Manual (Page 37)

3
S
YSTEM
S
ERVICE
C
OMMANDS
Use system services commands to configure and monitor system
information for a WX switch.
Commands by
Usage This chapter presents system service commands alphabetically. Use
Table 6 to locate commands in this chapter based on their use.
Table 6 System Services Commands by Usage
Type Command
Configuration quickstart on page 48
Auto-Config set auto-config on page 48
Display clear banner motd on page 38
quickstart on page 48
display banner motd on page 41
set confirm on page 52
set length on page 53
System Identification set prompt on page 54
set system name on page 60
set system location on page 59
set system contact on page 55
set system countrycode on page 56
set system idle-timeout on page 58
set system idle-timeout on page 58
display load on page 43
display system on page 43
clear system on page 40