Display tunnel – 3Com Wireless LAN WX1200 User Manual
Page 110
110
C
HAPTER
5: VLAN C
OMMANDS
See Also
clear security 12-restrict on page 99
clear security 12-restrict counters on page 100
set security l2-restrict on page 114
display tunnel
Shows the tunnels from the wireless LAN switch where you type the
command.
Syntax —
display tunnel
Defaults — None.
Access — Enabled
History —Introduced in MSS Version 3.0.
Examples — To display all tunnels from a WX switch to other WX
switches in the Mobility Domain, type the following command.
WX4400# display tunnel
VLAN
Local Address
Remote Address State
Port LVID RVID
--------------- --------------- --------------- ------- ----- ----- -----
vlan-eng
192.168.14.2
192.168.14.4 DORMANT 1024 4096
130
Table 25 describes the fields in the display.
Hits
Number of packets whose source MAC address was a
client in this VLAN, and whose destination MAC address
was one of those listed under Permit MAC.
Table 24 Output for display security 12-restrict
Field
Description
Table 25 Output for display tunnel
Field
Description
VLAN
VLAN name.
Local Address
IP address of the local end of the tunnel. This is the system
IP address of the wireless access switch where you enter
the command.