Snoop commands, Commands by usage, Noop – 3Com Wireless LAN WX1200 User Manual
Page 597: Ommands
22
S
NOOP
C
OMMANDS
Use snoop commands to monitor wireless traffic, by using a Distributed
MAP as a sniffing device. The MAP copies the sniffed 802.11 packets and
sends the copies to an observer, which is typically a protocol analyzer
such as Ethereal or Tethereal.
(For more information, including setup instructions for the monitoring
station, see the “Remotely Monitoring Traffic” section in the
“Troubleshooting a WX Switch” chapter of the
Wireless LAN Switch and
Controller Configuration Guide
.)
Commands by
Usage
This chapter presents snoop commands alphabetically. Use the following
table to locate commands in this chapter based on their use.
Table 108 Remote Monitoring (Snooping) Commands By Usage
Remote
monitoring
(snooping)
display snoop info on page 604
display snoop stats on page 606
22