3Com Wireless LAN WX1200 - Manual (Page 328)

328 C HAPTER 11: M ANAGED A CCESS P OINT C OMMANDS
Examples — The following command enables the profile for automatic
Distributed MAP configuration:
WX4400# set dap auto mode enable
success: change accepted.
See Also
„
set dap auto on page 325
„
set dap auto radiotype on page 326
„
set {ap | dap} bias on page 328
„
set {ap | dap} blink on page 330
„
set {ap | dap} group on page 332
„
set {ap | dap} radio auto-tune max-power on page 335
„
set {ap | dap} radio auto-tune max- retransmissions on page 337
„
set {ap | dap} radio auto-tune min-client-rate on page 340
„
set {ap | dap} radio mode on page 341
„
set {ap | dap} radio radio-profile on page 343
„
set {ap | dap} upgrade-firmware on page 346
set {ap | dap} bias Changes the bias for a MAP. Bias is the priority of one WX switch over
other WX switches for booting and configuring the MAP.
Syntax — set {ap port-list | dap dap-num | auto} bias {high
| low}
„
ap port-list — List of ports on which to change the bias for directly
connected MAPs.
„
dap dap-num — Number of a Distributed MAP for which to change
the bias.
„
dap auto — Configures bias for the MAP configuration profile. (See
set dap auto on page 325.)
„
high — High bias.
„
low — Low bias.
Defaults — The default bias is high.