3Com Wireless LAN WX1200 - Manual (Page 574)

574 C HAPTER 20: F ILE M ANAGEMENT C OMMANDS
Booted configuration: file:configuration
Product model: WX
Table 105 describes the fields in the display boot output.
See Also
„
display version on page 576
„
reset system on page 582
„
set boot configuration-file on page 586
display config Displays the configuration running on the WX switch.
Syntax — display config [area area] [all]
„
area area — Configuration area. You can specify one of the
following:
„
aaa
„
acls
„
ap
„
arp
„
eapol
Table 105 Output for display boot
Field Description
Configured boot
version Software version the switch will run next time the software is
rebooted.
Configured boot
image Boot partition and image filename MSS will use to boot next
time the software is rebooted.
Configured boot
configuration Configuration filename MSS will use to boot next time the
software is rebooted.
Backup boot
configuration The name of the configuration file to be used in the event
that MSS cannot read the configured boot configuration file
next time the software is rebooted.
Booted version Software version the switch is running.
Booted image Boot partition and image filename MSS used the last time
the software was rebooted. MSS is running this software
image.
Booted configuration Configuration filename MSS used to load the configuration
the last time the software was rebooted.