3Com Wireless LAN WX1200 User Manual

Page 368

368

HAPTER

11: M

ANAGED

CCESS

OINT

OMMANDS

Access — Enabled.

History —Introduced in MSS Version 3.0.

Usage — You must configure the service profile before you can map it to
a radio profile. You can map the same service profile to more than one
radio profile.

You must disable all radios that use a radio profile before you can change
parameters in the profile. Use the set radio-profile mode command.

Examples — The following command maps service-profile wpa_clients
to radio profile rp2:

WX4400# set radio-profile rp2 service-profile wpa_clients
success: change accepted.

See Also

display service-profile on page 321

set service-profile auth-dot1x on page 373

set service-profile auth-fallthru on page 374

set service-profile auth-psk on page 375

set service-profile beacon on page 376

web-aaa-form

Not configured For WebAAA users, serves the default

wep key-index

No keys
defined

Uses dynamic WEP rather than static WEP.

If you configure a WEP key for static WEP,
MSS continues to also support dynamic
WEP.

wep active-
multicast-index

Uses WEP key 1 for static WEP encryption
of multicast traffic if WEP encryption is
enabled and keys are defined.

wep active-unicast-
index

Uses WEP key 1 for static WEP encryption
of unicast traffic if WEP encryption is
enabled and keys are defined.

wpa-ie

disable

Does not use the WPA IE in transmitted
frames.

Table 67 Defaults for Service Profile Parameters (continued)

Parameter

Default Value

Radio Behavior When Parameter Set
to Default Value