3Com Wireless LAN WX1200 - Manual (Page 33)

2
A
CCESS
C
OMMANDS
This chapter describes access commands used to control access to the
Mobility Software System (MSS) command-line interface (CLI).
Commands by
Usage This chapter presents access services commands alphabetically. Use
Table 5 to located commands in this chapter based on their use.
disable Changes the CLI session from enabled mode to restricted access.
Syntax — disable
Defaults — None.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Examples — The following command restricts access to the CLI for the
current session:
WX1200# disable
WX1200>
See Also
„
enable on page 34
Table 5 Access Commands by Usage
Type Command
Access Privileges enable on page 34
set enablepass on page 35
disable on page 33
quit on page 34