3Com Wireless LAN WX1200 - Manual (Page 491)

set radius client system-ip 491
„
retransmit — 3 (the total number of attempts, including the first
attempt)
„
timeout — 5 seconds
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — You can specify only one parameter per command line.
Examples — The following commands sets the dead time to 5 minutes,
the RADIUS key to goody, the number of retransmissions to 1, and the
timeout to 21 seconds on all RADIUS servers connected to the WX
switch:
WX1200# set radius deadtime 5
success: change accepted.
WX1200# set radius key goody
success: change accepted.
WX1200# set radius retransmit 1
success: change accepted.
WX1200# set radius timeout 21
success: change accepted.
See Also
„
clear radius server on page 489
„
display aaa on page 219
„
set radius server on page 494
set radius client
system-ip Causes all RADIUS requests to be sourced from the IP address specified by
the set system ip-address command, providing a permanent source IP
address for RADIUS packets sent from the WX switch.
Syntax — set radius client system-ip
Defaults — None. If you do not use this command, RADIUS packets
leaving the WX have the source IP address of the outbound interface,
which can change as routing conditions change.
Examples — Enabled.
History —Introduced in MSS Version 3.0.