Display fdb – 3Com Wireless LAN WX1200 User Manual
Page 102
102
C
HAPTER
5: VLAN C
OMMANDS
The following command completely removes VLAN marigold:
WX4400# clear vlan marigold
This may disrupt user connectivity.
Do you wish to continue? (y/n) [n]y
success: change accepted.
See Also
display vlan config on page 111
display fdb
Displays entries in the forwarding database.
Syntax —
display fdb [mac-addr-glob [vlan vlan-id ]]
display fdb {perm | static | dynamic | system | all} [port
port-list | vlan vlan-id]
mac-addr-glob
— A single MAC address or set of MAC addresses.
Specify a MAC address, or use the wildcard character (*) to specify a
set of MAC addresses. (For details, see “MAC Address Globs” on
page 27.)
vlan
vlan-id
— Name or number of a VLAN for which to display
entries.
perm
— Displays permanent entries. A permanent entry does not age
out and remains in the database even after a reboot, reset, or power
cycle.
static
— Displays static entries. A static entry does not age out, but
is removed from the database after a reboot, reset, or power cycle.
dynamic
— Displays dynamic entries. A dynamic entry is automatically
removed through aging or after a reboot, reset, or power cycle.
system
— Displays system entries. A system entry is added by MSS.
For example, the authentication protocols can add entries for wired
and wireless authentication users.
all
— Displays all entries in the database, or all the entries that match
a particular port or ports or a particular VLAN.
port
port-list — Destination port(s) for which to display entries.
Defaults — None.