3Com Wireless LAN WX1200 - Manual (Page 150)

150 C HAPTER 7: IP S ERVICES C OMMANDS
Examples — To display NTP information for a WX switch, type the
following command:
WX4400> display ntp
NTP client: enabled
Current update-interval: 20(secs)
Current time: Fri Feb 06 2004, 12:02:57
Timezone is set to 'PST', offset from UTC is -8:0 hours.
Summertime is enabled.
Last NTP update: Fri Feb 06 2004, 12:02:46
NTP Server Peer state Local State
---------------------------------------------------
192.168.1.5 SYSPEER SYNCED
Table 39 describes the fields in this display.
Table 39 Output for display ntp
Field Description
NTP client State of the NTP client. The state can be one of the
following:
„
Enabled
„
Disabled
Current update-interval Number of seconds between queries sent by the WX
switch to the NTP servers for updates.
Current time System time that was current on the WX switch when you
pressed Enter after typing the display ntp command.
Timezone Time zone configured on the WX switch. MSS offsets the
time reported by the NTP server based on the time zone.
This field is displayed only if you change the time zone.
Summertime Summertime period configured on the WX switch. MSS
offsets the system time +1 hour and returns it to standard
time for daylight savings time or a similar summertime
period that you set.
This field is displayed only if you enable summertime.
Last NTP update Time when the WX switch received the most recent
update from an NTP server.
NTP Server IP address of the NTP server.