Set log – 3Com Wireless LAN WX1200 User Manual
Page 614
614
C
HAPTER
23: S
YSTEM
L
OG
C
OMMANDS
Defaults — None.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Examples — Type the following command to see the facilities for which
you can view event messages archived in the buffer:
WX4400# display log trace facility ?
ASO, BOOT, CLI, CLUSTER, COPP, CRYPTO, DOT1X, ENCAP, ETHERNET, GATEWAY, HTTPD,
IGMP, IP, MISC, NOSE, NP, RAND, RESOLV, RIB, ROAM, ROGUE, SM, SNMPD, SPAN, STORE,
SYS, TAGMGR, TBRIDGE, TCPSSL, TELNET, TFTP, TLS, TUNNEL, VLAN, X509, XML, MAP,
RAPDA, WEBVIEW, EAP, PORTCONFIG, FP.
See Also
display log config on page 612
set log
Enables or disables logging of WX and MAP events to the WX log buffer
or other logging destination and sets the level of the events logged. For
logging to a syslog server only, you can also set the facility logged.
Syntax —
set log {buffer | console | current | server ip-addr
| sessions
|
trace}
[severity
severity-level] enable
|
disable]
Syntax —
set log server ip-addr [severity severity-level
[local-facility facility-level]] [enable | disable]
buffer
— Sets log parameters for the log buffer in nonvolatile
storage.
console
— Sets log parameters for console sessions.
current
— Sets log parameters for the current Telnet or console
session. These settings are not stored in nonvolatile memory.
server
ip-addr
— Sets log parameters for a syslog server. Specify an
address in dotted decimal notation.
sessions
— Sets the default log values for Telnet sessions. You can
set defaults for the following log parameters:
Severity