Set radio-profile auto-tune power-backoff- timer – 3Com Wireless LAN WX1200 User Manual
Page 352
352
C
HAPTER
11: M
ANAGED
A
CCESS
P
OINT
C
OMMANDS
Examples — The following command sets the channel interval for radios
in radio profile rp2 to 2700 seconds (45 minutes):
WX4400# set radio-profile rp2 auto-tune channel-interval 2700
success: change accepted.
See Also
set radio-profile auto-tune channel-config on page 349
set radio-profile auto-tune channel-holddown on page 350
set radio-profile
auto-tune
power-backoff-
timer
Sets the interval at which radios in a radio profile reduce power after
temporarily increasing the power to maintain the minimum data rate for
an associated client. At the end of each power-backoff interval, radios
that temporarily increased their power reduce it by 1 dBm. The power
backoff continues in 1 dBm increments after each interval until the power
returns to expected setting.
Syntax —
set
radio-profile
name auto-tune
power-backoff-timer
seconds
name
— Radio profile name.
seconds
— Number of seconds radios wait before lowering the power
by 1 dBm. You can specify from 0 to 65535 seconds.
Defaults — The default power-backoff interval is 10 seconds.
Access — Enabled.
History —Introduced in MSS Version 3.0.
A radio can increase power again if required to preserve the minimum
data rate for an associated client.
Examples — The following command changes the power-backoff
interval for radios in radio profile rp2 to 15 seconds:
WX4400# set radio-profile rp2 auto-tune
power-backoff-timer 15
success: change accepted.
See Also