3Com Wireless LAN WX1200 - Manual (Page 172)

172 C HAPTER 7: IP S ERVICES C OMMANDS
History —Introduced in MSS Version 3.0.
Examples — The following command changes the Telnet port number
on a WX switch to 5000:
WX4400# set ip telnet 5000
success: change accepted.
See Also
„
clear ip telnet on page 131
„
display ip https on page 145
„
display ip telnet on page 148
„
set ip https server on page 167
„
set ip telnet server on page 172
set ip telnet server Enables the Telnet server on a wireless LAN switch.
CAUTION: If you disable the Telnet server, Telnet access to the WX
switch is also disabled.
Syntax — set ip telnet server {enable | disable}
„
enable — Enables the Telnet server.
„
disable — Disables the Telnet server.
Defaults — The Telnet server is disabled by default.
Access — Enabled.
Usage — The maximum number of Telnet sessions supported on a WX
switch is eight. If SSH is also enabled, the WX switch can have up to eight
Telnet or SSH sessions, in any combination, and one console session.
Examples — The following command enables the Telnet server on a WX
switch:
WX4400# set ip telnet server enable
success: change accepted.
See Also
„
clear ip telnet on page 131