3Com Wireless LAN WX1200 - Manual (Page 533)

19
RF D
ETECTION
C
OMMANDS
MSS automatically performs RF detection scans on enabled and disabled
radios to detect rogue access points. A rogue access point is a BSSID
(MAC address associated with an SSID) that does not belong to a 3Com
switch and is not a member of the ignore list configured on the seed
switch of the Mobility Domain. The ignore list is a list of third-party
(friendly) BSSIDs that are not rogues.
MSS can issue countermeasures against rogue devices to prevent clients
from being able to use them.
You can configure RF detection parameters only on the seed switch of a
Mobility Domain.
Commands by
Usage This chapter presents RF detection commands alphabetically. Use
Table 94 to locate the commands in this chapter based on their use.
Table 94 RF Detection Commands by Usage
Type Command
Rogue Information display rfdetect clients on page 539
display rfdetect mobility-domain on page 546
display rfdetect data on page 544
display rfdetect visible on page 552
display rfdetect counters on page 542
Countermeasures display rfdetect countermeasures on page 541
Permitted Vendor
List set rfdetect vendor-list on page 561