Set snmp protocol, Set snmp protocol on page 186, Set snmp security on page 187 – 3Com Wireless LAN WX1200 User Manual
Page 186: Set snmp usm on page 188, Display snmp notify target on page 152, Snmpv1, Snmpv2c, Snmpv3 (with the user security model), Enables all supported versions of snmp, Enables the specified snmp version(s)
186
C
HAPTER
7: IP S
ERVICES
C
OMMANDS
display snmp notify target on page 152
set snmp protocol
Enables an SNMP protocol. MSS supports SNMPv1, SNMPv2c, and
SNMPv3.
Syntax —
set snmp protocol {v1 | v2c | usm | all} {enable | disable}
v1
— SNMPv1
V2c
— SNMPv2c
usm
— SNMPv3 (with the user security model)
all
— Enables all supported versions of SNMP.
enable
— Enables the specified SNMP version(s).
disable
— Disables the specified SNMP version(s).
Defaults — All SNMP versions are disabled by default.
Access — Enabled.
History —Introduced in MSS Version 4.0.
Usage — SNMP requires the switch’s system IP address to be set. SNMP
will not work without the system IP address.
You also must enable the SNMP service using the set ip snmp server
command.
Examples — The following command enables all SNMP versions:
WX1200# set snmp protocol all enable
success: change accepted.
See Also
set ip snmp server on page 169