3Com Wireless LAN WX1200 - Manual (Page 131)

clear ip telnet 131
clear ip telnet Resets the Telnet server’s TCP port number to its default value. A WX
switch listens for Telnet management traffic on the Telnet server port.
Syntax — clear ip telnet
Defaults — The default Telnet port number is 23.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Examples — The following command resets the TCP port number for
Telnet management traffic to its default:
WX4400# clear ip telnet
success: change accepted.
See Also
„
display ip https on page 145
„
display ip telnet on page 148
„
set ip https server on page 167
„
set ip telnet on page 171
„
set ip telnet server on page 172
clear ntp server Removes an NTP server from a WX switch configuration.
Syntax — clear ntp server {ip-addr | all}
„
ip-addr — IP address of the server to remove, in dotted decimal
notation.
„
all — Removes all NTP servers from the configuration.
Defaults — None.
Access — Enabled.
History — Introduced in MSS Version 3.0.