3Com Wireless LAN WX1200 - Manual (Page 156)

156 C HAPTER 7: IP S ERVICES C OMMANDS
Examples — To display the offset from UTC, type the following
command:
WX4400# display timezone
Timezone set to 'pst', offset from UTC is -8 hours
See Also
„
clear summertime on page 135
„
clear timezone on page 136
„
display summertime on page 154
„
display timedate on page 155
„
set summertime on page 191
„
set timedate on page 193
„
set timezone on page 194
ping Tests IP connectivity between a wireless LAN switch and another device.
MSS sends an Internet Control Message Protocol (ICMP) echo packet to
the specified WX switch and listens for a reply packet.
Syntax — ping host [count num-packets ] [dnf] [flood]
[interval time] [size size] [source-ip ip-addr | vlan-name]
„
host — IP address, MAC address, hostname, alias, or user to ping.
„
count num-packets — Number of ping packets to send. You can
specify from 0 through 2,147,483,647. If you enter 0, MSS pings
continuously until you interrupt the command.
„
dnf — Enables the Do Not Fragment bit in the ping packet to prevent
the packet from being fragmented.
„
flood — Sends new ping packets as quickly as replies are received, or
100 times per second, whichever is greater.
Use the flood option sparingly. This option creates a lot of traffic and can
affect other traffic on the network.
„
interval time — Time interval between ping packets, in
milliseconds. You can specify from 100 through 10,000.
„
size size — Packet size, in bytes. You can specify from 56 through
65,507.