3Com Wireless LAN WX1200 - Manual (Page 554)

554 C HAPTER 19: RF D ETECTION C OMMANDS
set rfdetect
active-scan Disables or reenables active RF detection scanning on a WX switch. When
active scanning is enabled, the MAP radios managed by the switch look
for rogue devices by sending probe any requests (probe requests with a
null SSID name), to solicit probe responses from other access points.
Syntax — set rfdetect active-scan {enable | disable}
„
enable — Enables active RF detection scanning.
„
disable — Disables active RF detection scanning.
Defaults — Active scanning is enabled by default.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — You can enter this command on any WX switch in the Mobility
Domain. The command takes effect only on that switch.
Examples — The following command disables active scanning on a WX
switch:
WX1200# set rfdetect active-scan disable
success: off-channel scanning is disabled.
set rfdetect
attack-list Adds an entry to the attack list. The attack list specifies the MAC
addresses of devices that MSS should issue countermeasures against
whenever the devices are detected on the network. The attack list can
contain the MAC addresses of APs and clients.
Syntax — set rfdetect attack-list mac-addr
„
mac-addr — MAC address you want to attack.
Defaults — The attack list is empty by default.
Access — Enabled.
History —Introduced in MSS Version 4.0.
Usage — The attack list applies only to the WX switch on which the list is
configured. WX switches do not share attack lists.