3Com Wireless LAN WX1200 - Manual (Page 362)

362 C HAPTER 11: M ANAGED A CCESS P OINT C OMMANDS
set radio-profile
mode Creates a new radio profile, or disables or reenables all MAP radios that
are using a specific profile.
Syntax — set radio-profile name [mode {enable | disable}]
„
radio-profile name — Radio profile name of up to 16 alphanumeric
characters, with no spaces.
Use this command without the mode enable or mode disable
option to create a new profile.
„
mode enable — Enables the radios that use this profile.
„
mode disable — Disables the radios that use this profile.
Defaults — Each radio profile that you create has a set of properties with
factory default values that you can change with the other set
radio-profile commands in this chapter. Table 66 lists the parameters
controlled by a radio profile and their default values.
Table 66 Defaults for Radio Profile Parameters
Parameter Default Value
Radio Behavior When Parameter Set to
Default Value
11g-only disable Allows associations with 802.11g and
802.11b clients.
Note: This parameter applies only to
802.11b/g radios.
active-scan enable Sends probe any requests (probe requests
with a null SSID name) to solicit probe
responses from other access points.
auto-tune enable Allows dynamic configuration of channel
and power settings by MSS.
beacon-interval 100 Waits 100 ms between beacons.
countermeasures Not configured Does not issue countermeasures against
any device.
dtim-interval 1 Sends the delivery traffic indication map
(DTIM) after every beacon.
frag-threshold 2346 Transmits frames up to 2346 bytes long
without fragmentation.
long-retry 5 Sends a long unicast frame up to five times
without acknowledgment.