3Com Wireless LAN WX1200 - Manual (Page 292)

292 C HAPTER 11: M ANAGED A CCESS P OINT C OMMANDS
name MAP access point name.
boot-download-
enable State of the firmware upgrade option:
„
YES (automatic upgrades are enabled)
„
NO (automatic upgrades are disabled)
load balancing group Names of the MAP load-balancing groups to which the MAP
access point belongs. If the value is None, the access point
does not belong to any load balancing groups.
Note: This field is displayed only if the MAP is a member of a
group.
Radio Radio number. The information listed below this field applies
specifically to the radio.
type Radio type:
„
802.11a
„
802.11b
„
802.11g
mode Radio state:
„
Enabled
„
Disabled
channel Channel number.
antennatype External antenna model, if applicable.
tx pwr Transmit power, in dBm.
profile Radio profile that manages the radio. Until you assign the
radio to a radio profile, MSS assigns the radio to the default
radio profile.
auto-tune
max-power Maximum power level the RF Auto-Tuning feature can set on
the radio.
„
The value default means RF Auto-Tuning can set the
power up to the maximum level allowed for the country
of operation.
„
A specific numeric value means you or another
administrator set the maximum value.
auto-tune
min-client-rate Minimum data rate the radio must maintain for associated
clients. When RF Auto-Tuning is enabled, the radio can
temporarily increase its power to maintain the data rate with
an associated client.
Table 51 Output for display ap config (continued)
Field Description