3Com Wireless LAN WX1200 - Manual (Page 339)

set {ap | dap} radio channel 339
set {ap | dap} radio
channel Sets a MAP radio’s channel.
Syntax — set {ap port-list | dap dap-num} radio {1 | 2}
channel channel-number
„
ap port-list — List of ports connected to the MAP access points on
which to set the channel.
„
dap dap-num — Number of a Distributed MAP on which to set the
channel.
„
radio 1 — Radio 1 of the MAP.
„
radio 2 — Radio 2 of the MAP. (This option does not apply to
single-radio models.)
„
channel channel-number — Channel number. The valid channel
numbers depend on the country of operation.
Defaults — The default channel depends on the radio type:
„
The default channel number for 802.11b/g is 6.
„
The default channel number for 802.11a is the lowest valid channel
number for the country of operation.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — You can configure a radio’s transmit power on the same
command line. Use the tx-power option.
This command is not valid if dynamic channel tuning (RF Auto-Tuning) is
enabled.
Examples — The following command configures the channel on the
802.11a radio on the MAP access point connected to port 5:
WX1200# set ap 5 radio 1 channel 36
success: change accepted.
The following command configures the channel and transmit power on
the 802.11b/g radio on the MAP access point connected to port 1:
WX1200# set ap 1 radio 1 channel 1 tx-power 10
success: change accepted.