3Com Wireless LAN WX1200 - Manual (Page 394)

394 C HAPTER 12: STP C OMMANDS
clear spantree
portcost Resets to the default value the cost of a network port or ports on paths to
the STP root bridge in all VLANs on a WX switch.
Syntax — clear spantree portcost port-list
„
port-list — List of ports. The port cost is reset on the specified ports.
Defaults — None.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — This command resets the cost in all VLANs. To reset the cost for
only specific VLANs, use the clear spantree portvlancost command.
Examples — The following command resets the STP port cost on ports 5
and 6 to the default value:
WX1200# clear spantree portcost 5-6
success: change accepted.
See Also
„
clear spantree portvlancost on page 395
„
display spantree on page 398
„
display spantree portvlancost on page 403
„
set spantree portcost on page 414
„
set spantree portvlancost on page 417
Fast
Convergence,
cont. set spantree backbonefast on page 411
display spantree backbonefast on
page 400
set spantree uplinkfast on page 419
display spantree uplinkfast on page 409
Statistics display spantree statistics on page 403
clear spantree statistics on page 397
Table 68 STP Commands by Usage (continued)
Type Command