3Com Wireless LAN WX1200 - Manual (Page 167)

set ip https server 167
set ip https server Enables the HTTPS server on a wireless LAN switch. The HTTPS server is
required for Web Manager access to the switch.
CAUTION: If you disable the HTTPS server, Web Manager access to the
WX switch is also disabled.
Syntax — set ip https server {enable | disable}
„
enable — Enables the HTTPS server.
„
disable — Disables the HTTPS server.
Defaults — The HTTPS server is disabled by default.
Access — Enabled.
History — The default is changed to disabled in 3.1. In addition, the
HTTPS server is no longer required for WebAAA.
Examples — The following command enables the HTTPS server on a WX
switch:
WX1200# set ip https server enable
success: change accepted.
See Also
„
clear ip telnet on page 131
„
display ip https on page 145
„
display ip telnet on page 148
„
set ip telnet on page 171
„
set ip telnet server on page 172
set ip route Adds a static route to the IP route table.
Syntax — set ip route {default | ip-addr mask |
ip-addr/mask-length} gateway metric
„
default — Default route. A WX switch uses the default route if an
explicit route is not available for the destination.
Default is an alias for IP address 0.0.0.0/0.