Xerox 180 - Manual (Page 98)

SYSTEM CONTROL TASKS
4-14 XEROX DOCUPRINT 180 LPS OPERATOR GUIDE
Turn off Attention light or alarm
Use this task to turn off the Attention light. Neither the steady nor
flashing modes of the Attention light operate, and the Hint and Fault
icons do not appear on the PC UI and the printer control console.
When the next fault condition occurs, the Attention light and
appropriate icons appear again.
Turn off Attention Light task
through windows
Select the appropriate Disabled button(s) as follows:
Steady Light:
Select this button to disable the Steady Attention light located on top
of the printer.
Alarm:
Select this button to disable the audible alarm.
Flashing Light:
Select this button to disable the Flashing Attention light located on
top of the printer.
Turn off Attention Light task
through command line
Enter the following command:
ATTENTION ALL OFF
Energy saver
To conserve energy and prolong the life of some of its critical parts,
the LPS was designed with a power saver mode. After a
predetermined period of inactivity, portions of the printer are shut
down. The time-out period is factory set, but it can be readjusted.
Heating and cooling are the most costly uses of electricity.
Therefore, maintaining the system at full temperature while idle is not
cost effective. After four hours of inactivity (or whatever time period
you set), the fusing system shuts down. Once it cools down, it
requires the same four- to seven-minute warm-up time as if the
system had been turned off.
Use the Energy Saver task to readjust the time-out period. The
energy saver timer starts whenever the printer stops.
Energy Saver task through windows Perform the following steps: