Tape does not unload, Unloading a cartridge after a power failure, Tape winds completely out of cartridge – Xerox 180 User Manual

Page 313

PROBLEM SOLVING TASKS

XEROX DOCUPRINT 180 LPS OPERATOR GUIDE

12-33

Tape does not unload

To solve this problem:

Step 1.

If there is an error code message on the message display, record the
error code.

Step 2.

Press the Unload button (see figure 12-40).

Figure 12-40. Unload buttons

Step 3.

Try unloading the tape again.

Step 4.

If the tape still does not unload, record the error code on the message
display, record the time, and call for service.

Unloading a cartridge after a power failure

To unload a cartridge after a power failure:

Step 1.

Turn the tape drive on. (Refer to the “Emergency procedures”
section of the “Offline printing tasks” chapter.)

Step 2.

Press the Unload button.

Tape winds completely out of cartridge

Call for service. If there is an error code message on the message
display, record the code and report it to the service representative.

Unload
button