Xerox 180 User Manual
Page 66

PAPER FACTS
3-6
XEROX DOCUPRINT 180 LPS OPERATOR GUIDE
1.
Refer to the Paper stocks guide for additional information.
2.
Optional 7 X 10 enablement kit allows 7 by 10 inches/178 by 254 mm paper size.
3.
Make sure that heavy weight paper levers (located in areas 2 and 4 of the printer) are in the appropriate
position for the weight of paper being used. Refer to the “Prints are skewed” section of the “Problem solving
tasks“ chapter
4.
Curl direction should be determined before loading paper into trays. Refer to the “Paper jams and paper curl”
section of chapter 12, “Problem solving tasks,” for additional information.
5.
Curl direction should be determined before loading paper into trays. Refer to the “Paper jams and paper curl”
section of chapter 12, “Problem solving tasks,” for additional information.
Table 3-4.
Two-sided (duplex) printing performance guide
1
Paper
Superior performance
Good performance
Performance limits and
suggested alternatives
Size range
2
8 by 10 to 11.69 by 17 inches/
203 by 254 to 297 by 432 mm.
Smaller or larger sizes cannot
be used.
Weight range
20 to 110 pounds/80 to 200
gsm
3
Weights outside the limits
shown are not recommended.
If show through occurs, adjust
print quality or use heavier
weight paper.
Type or
condition
•
Xerographic paper in
good condition
•
Predrilled stock (fanned
thoroughly)
•
Slightly curled paper
4
•
Paper with reinforced
binding edges
•
Tabs
Refer to the Paper Stocks
Guide for additional
information.
•
Excessively curled
paper
5
•
Avoid Transparencies
Stock not defined here is
included in the Paper Stocks
Guide, which follows.