Xerox 180 - Manual (Page 278)

MAINTENANCE TASKS
11-22 XEROX DOCUPRINT 180 LPS OPERATOR GUIDE
Using the custom transfer assist blade
The transfer assist blade in the Xerox DocuPrint 180 LPS assures
good print quality for your jobs. A kit is available allowing you to
customize a transfer assist blade for use with non-standard paper
size.
When not to use the custom transfer assist blade
You cannot use the custom transfer assist blade for print jobs that
use more than one paper size. In addition, the following range of
paper lengths cannot use the custom blade:
• In U.S. markets
— 11.1 to 11.4 inches/282 to 290 mm
— 11.8 to 12.1 inches/300 to 307 mm
— 13 to 13.5 inches/330 to 343 mm.
•
In non-U.S. markets
— 11.1 inches to 11.4 inches/282 to 290 mm
— 11.8 inches to 12.1 inches/300 to 307 mm.
Note: With these paper sizes, transfer efficiency may be reduced.
Caution: For the above paper sizes, the standard transfer assist
blade must be used.
Caution: To avoid damage to the photoreceptor, you must perform
the Set Tray Size task explained in the “Status and print tasks”
chapter.
Installing the custom transfer assist blade
The custom transfer assist blade comes in a package containing
detailed instructions. Be sure to follow the instructions carefully.
Caution: To prevent damage to the LPS, have your service
representative show you the procedure before you attempt to
customize and install a custom transfer assist blade for the first time.