Xerox 180 - Manual (Page 217)

STATUS AND PRINT TASKS
XEROX DOCUPRINT 180 LPS OPERATOR GUIDE 9-19
Ordered Stock task through command
line
Enter the following command:
OSTK m,n
Table 9-3 lists each parameter and its description.
For example:
1. You are printing a job using prenumbered sheets of paper,
numbered from 1-10, feeding from tray 3.
2. You remove some sheets from the top of the stack in tray 3.
3. The LPS expects the next sheet to be number 3, though it is, in
fact, number 6.
4. Use the OSTK command in the following way:
OSTK 3 6
The above command tells the LPS that page 6 is ready to be
printed from the ordered stock in tray 3
Note: Changes made through the command line are not reflected
in the Ordered Stock window.
Transparencies
Transparencies:
•
Can feed only from the processor feeder trays (trays 1 and 2)
•
Are printed only in simplex (one-sided) mode
• Must be delivered to the sample tray.
The Transparencies task allows you to override or request the use of
transparencies for a particular print job. The Transparencies task:
•
Can be entered only when the system is idle (that is, not
printing and not engaged in any nonprinting tasks)
• Causes or cancels the use of transparencies in the next print
job.
Once the job has printed, the transparency control returns to
the coding in the job stream. (Refer to the
Xerox DocuPrint 180
LPS PDL/DJDE Reference for additional information.)
Note: Changes made in the Trannsparencies window are not
reflected when the widow is reopened. The defaults are displayed
instead.
Table 9-3. OSTK command parameters and descriptions
Parameter Description
m The number of the tray containing the ordered
stock.
n The new position of the ordered stock.