Xerox 180 - Manual (Page 202)

STATUS AND PRINT TASKS
9-4 XEROX DOCUPRINT 180 LPS OPERATOR GUIDE
Status and print tasks
The following sections contain instructions for performing specific
status and print tasks.
Printer status
Use this task to display the current status of the feeder trays and
stacker bins. You see the following information:
•
Cluster names. The name of the cluster(s) (currently in use)
defined for each feeder tray.
• Feeder tray state. The state can be one of the following:
— In Use. The tray is in the current stockset (though paper
may not be feeding from it right now).
— Ready. The tray is ready to feed paper.
— Not Available. For example, the tray is broken.
— Busy. The tray elevator is raising or lowering.
— Lowered. The tray elevator is down.
— Empty. The tray does not contain any paper.
• Feeder tray size. Name or measurement of paper currently
assigned to the tray.
•
Paper tray levels. The levels depicted indicate:
— Empty
— 1/4 ream
— 1/2 ream
— 3/4 ream
— 1 ream
— 2 reams
— 3 reams
— 4 reams
— Full.
• Stacker bin state. The state can be one of the following:
— In Use. The current print job is stacking in the bin.
— Ready. The bin is ready to receive output.
— Not Available. For example, the bin is broken).
— Busy. The bin elevator is raising or lowering.
— Lowered. The bin elevator is down.
• Stacker bin size. The size is either:
— None. The bin is empty and containers are not being used.
Any size output can be stacked in the bin.
— x by y. The size of paper or container and paper currently
stacked in the bin.