Xerox 180 - Manual (Page 96)

SYSTEM CONTROL TASKS
4-12 XEROX DOCUPRINT 180 LPS OPERATOR GUIDE
Attention Light/Alarm
Use this task to enable or disable the Attention light and/or alarm.
The Attention light can be enabled or disabled for either or both
modes—steady and flashing. If, for example, you disable the steady
mode of the Attention light, but leave the flashing mode enabled, the
Attention light does not go on when a condition such as low dry ink
occurs (and the corresponding Hint icons do not appear on the PC UI
or the printer control console), but the Attention light still flashes
when the printer stops due to a fault (and the corresponding Fault
icons still appear on the PC UI and the printer control console).
Attention Light/Alarm task
through windows
Perform the following steps:
Step 1. Select “Attention Light/Alarm” from the System Control menu to open
the Attention Light/Alarm window.
Figure 4-11. Attention Light/Alarm window
Step 2. Select the appropriate Enabled button to enable the:
• Steady Attention light
• Flashing Attention light
•
Alarm.
Select the appropriate Disabled button to disable the:
• Steady Attention light
• Flashing Attention light
•
Alarm.
Step 3. Select the appropriate header button:
• Apply/Close. Apply your selection and close the window.
•
Apply. Apply your selection.
•
Close. Close the window.