Select stacker bins – Xerox 180 User Manual

Page 208

STATUS AND PRINT TASKS

9-10

XEROX DOCUPRINT 180 LPS OPERATOR GUIDE

Select stacker bins

Use this task to select the bin(s) used for stacking printed pages.
You can also select the sample tray or a finishing device as the
output destination.

The stacking order default is AUTOMODE, which specifies that:

•

Stacker A is used first.

•

The printed pages are sent to Stacker B when A is full, Stacker
C when A and B are full, etc.

If you specify a different stacking order through this task:

•

If the LPS is printing, the output goes to the selected bin (unless
it is full).

•

When the selected bin is full, the LPS sends output to the next
empty bin that can accept the paper size.

•

If no bin is available that can accept the paper size, the printer
stops and you must unload the bin(s).

•

If you select the sample tray, all printed pages are delivered
there until the report ends or you change the stacker bin
selection.

Select Stacker Bins task

through windows

Perform the following steps:

Step 1.

Select the Bin Mode header button from the Printer Status window to
open the Bin Mode window (see figure 9-5).

Figure 9-5.

Bin Mode window AUTO

Note:

Options C, D and E appear in the Bin Mode window only

if the system is configured with these options.

AUTO

SAMPLE TRAY