Xerox 180 - Manual (Page 186)

HIP PRINTING TASKS
8-4 XEROX DOCUPRINT 180 LPS OPERATOR GUIDE
Enter HIP communication mode
Use this task to enter HIP communication mode.
Note: This task is not necessary if you are using the PC UI
windows.
Enter HIP Communication Mode task
through command line
Enter the following command:
HIP [option[,option[,...]]]
HIP options are provided in this chapter in the task sections;
however, for a complete list and explanation of all available HIP
options, refer to the
Xerox DocuPrint 180 LPS Operations Reference.
Note the following:
• If your LPS has only one host and it is set up as the default host
in HIP.LIB, or if only one host is set up in HIP.Lib, entering HIP
has the same effect as entering HIP HOST, HIP ONLINE, and
HIP START.
• If your LPS has more than one host, then the one which is set
up as the default host in the HIP.Lib becomes active when you
enter the HIP command. If you want to use another host, you
must specify the host name.
•
The first time you enter HIP after performing a system
generation, you must specify a host name. This host is saved
in the recovery file of the system disk. If you do not enter a host
name, the following message appears:
HP2010 NO HOST SELECTED
•
If the host is not online and responding, the following message
appears every 15 seconds until the host comes online or HIP is
terminated:
HP1240 HOST NOT RESPONDING
Note: Note that listed options are separated by commas while
parameters are separated from the option keyword by a space.
The Xerox DocuPrint 180 LPS does not support the XNS host typye.
If XNS is selected as the host type, the following message will be
displayed:
INVALID HOST SELECTED
Command errors If an error is detected in the command line, the incorrect part of the
line is displayed. A message to correct and reenter the command is
made as follows:
HP2300 COMMAND IN ERROR AT: (part of command in
error)
HP2310 RE-ENTER COMMAND
Some commands are not valid for all hosts, and some commands are
not valid if a host is not selected. When this happens, one of the
following messages appears: