Xerox 180 - Manual (Page 97)

SYSTEM CONTROL TASKS
XEROX DOCUPRINT 180 LPS OPERATOR GUIDE 4-13
Attention Light/Alarm task
through command line
To enable the Attention light, enter the following command:
ATTENTION LIGHT ENABLE [STEADY | FLASHING]
Table 4-1 lists each parameter and its description.
To disable the Attention light, enter the following command:
ATTENTION LIGHT DISABLE [STEADY | FLASHING]
Table 4-2 lists each parameter and its description.
To enable the alarm, enter the following command:
ATTENTION ALARM ENABLE {0-10}
0-10 Sets the tone volume for the alarm. 0 is softest, 10 is loudest
volume.
To disable the alarm, enter the following command:
ATTENTION ALARM DISABLE
Table 4-1. ATTENTION LIGHT ENABLE command parameters
and descriptions
Parameter Description
STEADY Enables only the steady mode of the Attention
light.
FLASHING Enables only the flashing mode of the Attention
light.
Table 4-2. ATTENTION LIGHT DISABLE command
parameters and descriptions
Parameter Description
STEADY Disables only the steady mode of the Attention
light.
FLASHING Disables only the flashing mode of the Attention
light.