Xerox 180 - Manual (Page 174)

OFFLINE PRINTING TASKS
7-28 XEROX DOCUPRINT 180 LPS OPERATOR GUIDE
Offline printing tasks through command line
You can perform offline printing tasks by entering commands either:
•
Through the Messages window of the PC UI
• Through the system controller terminal (non-U.S. markets).
To enter commands through the Messages window of the PC UI:
Step 1. Place the cursor in the window.
Step 2. Click once with the left mouse button.
Step 3. Enter the command.
If you are using the system controller terminal, use the keyboard to
enter the command.
Offline printing tasks
The following sections contain instructions for performing specific
offline printing tasks.
Start an offline print job
Use this task to begin printing an offline job.
Start Job task through windows Through windows:
Step 1. Select the Offline button.
Step 2. From the Start window, enter information in the appropriate field(s):
•
Device. The tape drive you are using to print the job. (The tape
device identifications are set up during sysgen. Refer to the
Xerox DocuPrint 180 LPS System Generation Guide for
additional information.)
• Report Mode. There are two options for report mode:
— Single. The LPS stops after each job is printed. You can
then select the options for the next print job.
— Multiple. The LPS prints all the reports continuously.
The default for this field is “Multiple.”
•
JDE. The name or number of the job descriptor entry. It may be
up to eight characters in length.
•
JDL. The name or number of the job descriptor library, which
contains the JDE task used. It may be up to eight characters in
length.
• Copies. The number of copies you want.
•
Reports. Allows you to specify the sequence and set of reports
to be printed. For example, 1, 3-5, 2 directs the LPS to print the
first report, then the third through the fifth, then the second.