Xerox 180 - Manual (Page 32)

SYSTEM OVERVIEW OF THE XEROX DOCUPRINT 180 LPS
1-16 XEROX DOCUPRINT 180 LPS OPERATOR GUIDE
Mode. Is illuminated when the alternate mode has been selected.
Note: If all three indicators lights are flashing, a problem has
occurred and operator intervention is required.
Message display. Displays tape drive messages, menus, and error
codes. Messages such as LOADING, BOT, REWIND, CLEAN, are
displayed to show status. Other messages such as CST indicating a
standard length cassette, ECCST indicating an extended length
cassette, or CLEANING indicating a cleaning cartridge are also
displayed. The message display will also show a small flashing
square in the rightmost character space to indicate tape unit interface
activity.
Floppy disk drive
When installed, the optional floppy disk drive is located in the system
controller, to the right of the 1/4 inch cartridge tape drive. It allows you
to transfer files between a floppy disk and the system controller’s
hard disk.
Optional printer components
This section describes the following printer components:
•
Feeder/stacker
•
Bypass Transport Module
• Input enablement device
• 7 X 10 enablement kit
Feeder/stacker
The Xerox DocuPrint 180 has an inverter feeder stacker, and up to
three optional feeder stackers. Refer to the section “Printer
components” earlier in this chapter for information on the feeder
stacker.