Xerox 180 - Manual (Page 190)

HIP PRINTING TASKS
8-8 XEROX DOCUPRINT 180 LPS OPERATOR GUIDE
Start Job task through command line To start or continue printing jobs from HIP’s internal job queue, enter
the following command:
HIP START [DUMP][JID[,...]]
If no jid (job identification) parameters are specified, the entire queue
is processed in the order the jobs were received (or as reordered by
a previous START command).
If jids are specified, those jobs are reordered to the top of the job
queue, so they will be the next jobs submitted to OCS for processing.
Jobs that have already been submitted to OCS cannot be reordered.
The START commands issued to OCS are displayed when the job is
submitted.
If the optional DUMP parameter is specified, the specified job, or the
next job in the HIP’s queue, is submitted using the START command
parameters specified by the DUMPJOB command in the HIP file.
Only one job is submitted. After the job is submitted, HIP effects a
HIP STOP command.
If any listed jid is not eligible, it is listed in the message:
HP1150 CANNOT START JOB(S): n [,...]
Note that HIP may be taken offline temporarily with the HIP START
command. Should this occur, processing automatically continues
where it left off when HIP is put online again; that is, files are
accepted immediately from the host and printed from HIP’s internal
job queue.
If printing is to stop while the printing system is taken offline and
brought back online, enter the HIP STOP command. (Refer to the
next section of this chapter.)
Stop HIP print jobs
Use this task to stop HIP from submitting jobs for printing.
Stop Jobs task through windows Select the Stop header button from the HIP window.
Stop Jobs task through command line Enter the following command:
HIP STOP
Jobs already submitted for processing are not affected and are
processed.
Note: If jobs are being processed in job concatenation mode, enter
HIP DRAIN instead.