Xerox 180 - Manual (Page 125)

JOB CONTROL TASKS
XEROX DOCUPRINT 180 LPS OPERATOR GUIDE 5-11
If a job is printing, a page with the new value applied is delivered to
the sample tray. If no job is printing, the test form with the new value
applied is delivered to the sample tray. (See figure 5-5.)
To display the current image darkness value, enter the following
command:
DARKNESS
Lead edge screen
Use this task to apply a screen to the leading margin of a printed
sheet. The screen lightens a high density image in the margin. The
edge lightening change is applied to:
• The next print job
• The current print job if printing was interrupted.
If you select this task while the LPS is printing, the confirmation
window shown in figure 5-7 appears on the PC UI.
Figure 5-7. Confirmation window ("Lead Edge Screen" option)
Select Yes to continue with the Lead Edge Screen task, or select No
to cancel the task.
If you have the system controller terminal rather than the PC UI, the
following messages appears on the screen:
OS1331 LEAD EDGE SCREEN SETTING IS [OFF, NORMAL,
STRESS]
OS0500 OUTPUT STOPPED