Xerox 180 - Manual (Page 250)

FILE CONTROL TASKS
10-12 XEROX DOCUPRINT 180 LPS OPERATOR GUIDE
To copy files from system disk to unlabeled tape, enter the following
command:
COPY TAPE | CARTRIDGE | TD n WRITE [EBCDIC | ASCII] [ disk-
id] file-id
Table 10-5 lists each parameter and its description.
For example, if you key in COPY TAPE UNSYS.JSL, the file name is
UNSYS and the file type is “.JSL.”
Copy to/from floppy
Use this task to copy files from:
• System disk to floppy disk
• Floppy disk to system disk.
Note: This task is used for the optional floppy disk drive on the
system controller, not the PC UI floppy disk drive.
Table 10-5. COPY command parameters and descriptions
Parameter Description
TAPE WRITE Indicates the file is to be written to a open-reel tape.
CARTRIDGE WRITE Indicates the file is to be written to an 1/2 inch cartridge
tape.
TD n WRITE Indicates the file is to be written to the specified tape
device.
EBCDIC ASCII The recording format of the tape being input. If you do not
specify either EBCDIC or ASCII, EBCDIC is assumed.
disk-id Tells which disk (DP0:, DP1:, DP2:, or DP3:) from which the
file is to be written. Keying in this parameter is not
necessary unless you want the file to be written from a
specific system disk.
file-id Gives the name of the file to be written from a system disk,
using the following form:
file-name.file-type.