Xerox 180 - Manual (Page 94)

SYSTEM CONTROL TASKS
4-10 XEROX DOCUPRINT 180 LPS OPERATOR GUIDE
System rollover message through
system controller terminal (non-U.S.
markets only)
If you are running the printer online, the system controller display
shows the following message:
OS2575 SYSTEM ROLLOVER. VARY OFFLINE FROM HOST.
ENTER ’C’
Perform the following steps:
Step 1. Enter “C” to initiate the recovery procedure. With either online or
offline mode, the following messages are displayed:
SYSTEM RECOVERY FROM #### ABORT
PRINT ABORT DATA FOR LATER ANALYSIS Y/N?
Step 2. Press for yes. PRINT REQUEST WILL BE QUEUED is
displayed. You are asked to verify date and time, and the following
messages are then displayed for online mode:
DO YOU WANT TO ATTEMPT AUTOMATIC JOB
RECOVERY? (’Y’ OR ’N’)
OS1061 INITIALIZING CSI
Step 3. Press for yes. The system rollover causes the LPS to go offline.
After the system rollover, the following messages are displayed:
OS0030 SYSTEM IS ’ONLINE’
OS2960 BACK UP HOST TO START OF REPORT
OR n PAGES, WHICHEVER IS LESS
OS2035 INPUT STOPPED. ENTER ’CONTINUE I’ WHEN
HOST IS READY
Step 4. The system automatically goes back online. Enter CONTINUE I to
resume printing. Any of the following messages may be displayed,
depending on the status of the system before the system rollover:
OS0010 RESUMING INPUT
OS0020 RESUMING OUTPUT
OS1650 OUTPUT PROCESSING HAS CAUGHT UP WITH
INPUT PROCESSING
OS4650 INPUT HAS RECOVERED TO PAGE BOUNDARY
OS4651 OUTPUT HAS RECOVERED TO PAGE
BOUNDARY
Printed output to be given to the analyst is generated after
completion of the job in progress. It follows the message:
OS1030 JOB #### HAS COMPLETED PRINTING
PERFORMING ABORT ANALYSIS DUMP
OS0040 SYSTEM IS OFFLINE
Step 5. Enter the ONLINE (for online mode) and START commands to
resume normal operation.