Xerox 180 User Manual

Page 132

JOB CONTROL TASKS

5-18

XEROX DOCUPRINT 180 LPS OPERATOR GUIDE

Sample Files task through

command line

To print a sample of a form, font, logo, or graphic stored on the
system disk, enter the following command:

SAMPLE

file-name.file-type [,D,copies]

Table 5-5 lists each parameter and its description.

Note:

For prints of graphics only, you may be asked to use the

HARDCOPY command instead of the SAMPLE command. There is
no difference in the graphic, but the data sheet that is printed with it
is more detailed when the HARDCOPY command is used.

To print samples of all files of a certain type, such as font, form, and
logo files, specify the type only. Enter the following command:

SAMPLE .

file-type [,D,copies]

Table 5-6 lists each parameter and its description.

Table 5-5.

SAMPLE command parameters and descriptions

Parameter

Description

file-name

The name of the file, obtained from your systems
personnel.

file-type

One of the following:

•

.FRM (form)

•

.FNT (font)

•

.IMG (graphic).

Print the samples on both sides of each sheet of
paper (duplex mode). If you do not enter a D, the
samples print on only one side of each sheet of
paper (simplex mode).

copies

The number of copies you want. If you do not
enter a number, one copy is printed.

Table 5-6.