Tape drive does not become ready – Xerox 180 User Manual

Page 315

PROBLEM SOLVING TASKS

XEROX DOCUPRINT 180 LPS OPERATOR GUIDE

12-35

Tape drive does not become ready

To solve this problem:

Step 1.

Determine if the tape drive is online by pressing the Scroll button until
the message display shows the Status display.

Step 2.

If the tape drive is offline, follow the procedures listed in the “Place
the tape drive online” section of the “Offline printing tasks” chapter.

Step 3.

If the drive still does not become ready, the cartridge may be inserted
incorrectly. Remove the cartridge from the transport and insert it
again.

Step 4.

If there is an error code message in the message display, record the
error code, press the Unload switch (see figure 12-43), and try the
operation again.

Figure 12-43.Unload switch

Step 5.

If the drive still does not become ready, call for service. If there is an
error code message on the message display, record the code and
report it to the service representative.

Unload button