Xerox 180 - Manual (Page 70)

PAPER FACTS
3-10 XEROX DOCUPRINT 180 LPS OPERATOR GUIDE
Feeder trays
Your LPS provides six feeder trays:
Two processor feeder trays
Four high-capacity feeder (HCF) trays.
(Refer to the “System overview of the Xerox DocuPrint 180 LPS”
chapter for additional information on the available feeder trays.)
Up to six different stocks may be used within a print job, including
oversize covers or tabs.
Note: If your LPS is fitted with a bulk feeder, the number of
available stocks increases by one.
For instructions on selecting feeder trays and managing clusters
(groupings of trays), refer to the “Status and print tasks” chapter.
Feeder tray features
Note the following features of the feeder trays:
• Any tray not currently in use can be opened, pulled out, and
loaded, without interrupting printing.
• If you try to open a tray currently in use, feeding switches to a
backup tray if one is available. If one is not available, the
printer stops.
• The printer does not feed all the paper out of a tray. (A stack of
approximately 1/4 inch/6 mm remains in the tray.)