Xerox 180 - Manual (Page 230)

STATUS AND PRINT TASKS
9-32 XEROX DOCUPRINT 180 LPS OPERATOR GUIDE
Job status
Use this task to display information about jobs in the print queue. The
following information appears:
• The print job queued for input (that is, processing).
•
Print job information for each job in the queue:
— Job number
— Customer job number
— Report number
— Report name
— Number of copies requested
— Total pages in the job
— Number of pages printed
— Number of pages printed
— Status of the job
— Status message number (either a blank if the print job
completed normally, an error message number, or “CS” if
the report is copy sensitive, that is, different copies of the
report contain different information).
When the system is printing, the status and source
information shown in figure 9-17 is displayed at the bottom
of the PC UI monitor.
Figure 9-17. Status and source information
•
Input Status. The processing stage of the job (for example,
“Idle”).
• Input source. The origin of the print job (for example, “Tape”).
•
Output Status. The printing stage of the job (for example,
“Printing”).
• Remote Status. The status of the remote communication (for
example, “Suspended”).
• Remote Source. The remote source of a job, if applicable (for
example, “Site PC”).
Note: When the system is idle, only the status information is
displayed: Input Status, Output Status, and Remote Status.
Input:
(Status)
(Source)
Output:
(Status)
Remote:
(Status)
(Source)