Xerox 180 - Manual (Page 279)

MAINTENANCE TASKS
XEROX DOCUPRINT 180 LPS OPERATOR GUIDE 11-23
Setting tray size with the custom transfer assist blades
When you are using the custom transfer assist blade, you must set
the tray length differently than described in the “Set tray size” section
of the “Status and print tasks” chapter. Use tables 11-1 and 11-2 to
determine the tray length setting to use.
Note: Set the tray width to the width of the custom paper.
Table 11-1. Tray length settings for custom transfer assist
blades (U.S. markets)
Paper size Set tray size to...
11.5 to 11.7 inches/292 to 297 mm 11.7 inches/297 mm
12.1 to 12.9 inches/307 to 328 mm 13 inches/330 mm
13 to 13.9 inches/330 to 353 mm 14 inches/356 mm
Table 11-2. Tray length settings for custom transfer assist
blades (Non-U.S. markets)
Paper size Set tray size to...
10 to 10.9 inches/254 to 277 mm 11 inches/279 mm
11.5 to 11.6 inches/292 to 294 mm 11.7 inches/297 mm
12.1 to 12.9 inches/307 to 328 mm 13 inches/330 mm