Xerox 180 - Manual (Page 127)

JOB CONTROL TASKS
XEROX DOCUPRINT 180 LPS OPERATOR GUIDE 5-13
Fonts/forms/graphics
In order to improve printer throughput, you can define the maximum
number of fonts, forms, and graphics that the system stores in
memory during a print job. The values remain in effect until you
change them or perform an LPS Update or Sysgen task. (Refer to
the
Xerox DocuPrint 180 LPS System Generation Guide for
additional information.)
Use the Fonts/Forms/Graphics task to set the maximum number for
the following:
• Fonts. Sets the maximum number of active fonts per print job.
No single printed page can have more fonts than this number.
Note: This number must include all fonts used on the form as
well as in the variable data.
If the number of fonts specified is exceeded during a print job,
the job aborts and a message displays in a message window on
the PC UI or the display screen of the system controller.
•
Forms. Sets the maximum number of active forms per print job.
Specifying a number larger than one allows form changes on a
page to page basis without negative effects on printing speed
as long as there is room for all the forms in system memory.
• Graphics. Sets the maximum number of active graphics per
print job. No single printed page may call for more than 16
graphics.
Note: This number must also include all graphics used on a
form for the page, if a form is used.