Toshiba Tosvert VF-AS1 - Manual (Page 26)

E6581301
A-10
1
For 200V/0.4kW to 200V/7.5kW models and 400V/0.75kW to 400V/11kW models, cut off the tabs (part A in the figure
below) on the main circuit terminal board if necessary for connecting the cables from the power supply.
200V-0.4kW~3.7/4.0kW
400V-0.75kW~3.7/4.0kW 200V-5.5kW~7.5kW
400V-5.5kW~11kW
A
A
■ Front cover
To wire the main circuit terminal board for models 200V-18.5kW or more and 400V-22kW or more, remove the front
cover.
Main circuit terminal board
Remove the screw
■ Control circuit terminal board cover
To wire the control circuit terminal board, open the control circuit terminal board cover in line with the steps given
below.
(1)
(2)
(2)
(3)
Control circuit terminal board
(1)
Open the control circuit terminal board cover.
* To open the cover, lift it with your finger
placed at the part on the right side of the
cover.
Remove the terminal board, if necessary.
*
To do so, open the main circuit terminal
board cover, loosen the screws that fix the
terminal board, using a (-) screwdriver or
torx (T20H) screwdriver, placed your
finger on part
and pull out the
terminal board.